The CAM systems like MasterCam and their ilk have taken the fun out of coding. I did CNC programming for Lockheed & Hewlett-Packard for 15 years but it’s been 20 yrs since I have written any tool paths. In the mean time I have Replied in the Fusion 360 PP thread and perhaps can gain some insight there. However, if that’s where you can provide the best advice, then who am I to argue! I’ll take another whack at it tomorrow. ![]() This implies that both are code that runs on the board… I presume a modified Arduino.Īs for ESTLCAM goes I was hoping not to have to learn multiple systems. ![]() Yes, I bought the board from you but am still a novice on the terminology… so not GRBL… yes Marlin. Thx Ryan… I have been reading the thread about the Fusion post-processor.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |